Where Can I Buy V Jointed Matching Tongue & Groove Board At A Finished Size Of 15Mm X 140Mm

Louise07 | 20:26 Wed 13th Feb 2013 | DIY

3 Answers

Where can I buy V Jointed Matching Tongue & Groove Board at a finished size of 15mm x 140mm. Everywhere I've looked so far are smaller than this. Thanks for any suggestions

Painting Plastic??

Replacement Door Handles

Answers

1 to 3 of 3

The Builder

Best Answer

It's not a stock item Louise. Around 90mm usually. If thickness isn't a problem, then use standard T&G floorboards. They finish at somewhere near 143mm. The thickness is between 20 and 22mm depending on where you get it from. You could have what you want made up , but it would cost a lot for them to set up the machines for a one-off job.

10:48 Thu 14th Feb 2013

Go To Best Answer

Old_Geezer

Just guessing here but probably a timber merchant could get it for you.

Although in my experience of DIY if you know exactly what you want, it isn't available, part of the skill is managing to change plans to use what one can get hold of.

The Builder

It's not a stock item Louise. Around 90mm usually. If thickness isn't a problem, then use standard T&G floorboards. They finish at somewhere near 143mm. The thickness is between 20 and 22mm depending on where you get it from.

You could have what you want made up , but it would cost a lot for them to set up the machines for a one-off job.

The Builder

I forgot to say that, with floorboards, you would have to run a small hand-plane down the edges to create the "V".

1 to 3 of 3

Do you know the answer?