How to cap a old hot feed from washing machine?

[lacuna bless]

Recently replacing my washing machine the hot feed cut off handle sheared off half open, I attempted capping the pipe as hot feed not required but modern machines only run on 15mm and 22mm according to wickes helper monkeys. As 15mm is too small and 22mm is too large can I use ptfe tape to make the thread meet on 22mm compression cap?? This hot feed is on main hot feed to sink and will have to hold against standard pressure.

Any helpful hints??
Alex

[scotman]

^^^^^^^^

I think Trim... means something like this

http://www.screwfix.c...arch=compression+stop

[lacuna bless]

Thank you for imput guys I forgot to mention im fitting onto existing connectors not exposed copper pipe. Would it b easier to remove the broken shut off connector and fit onto pipe???

[scotman]

are you trying to cap something like this

http://www.screwfix.c...rs-4.1/&company=ae235

[The Builder]

Even "old school" plumbers keep a load of these in their toolboxes these days. Important to smooth the end of the copper pipe as Trim says, or it'll rip the sealing ring ................. just push on............ no tools :o)

http://www.screwfix.c...-15mm-pack-of-2/94176