Film, Media & TV1 min ago
low pressure from hot water in bath?
4 Answers
the hot tap on my bathtub has very low pressure there is hardly any flow of water coming out at all but the other hot taps in my flat are fine (basin and kitchen) what could this problem be and how can i increase the water flow?
Answers
Best Answer
No best answer has yet been selected by dale_w. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.More information is needed before a possible answer. Has your hot tap on the bath always had low pressure? Do you have a combi boiler (all water at mains pressure) or a gravity fed system (header tank in loft or similar)? Usually the feed to bath taps is 22mm (3/4inch) pipe which should produce a good flow. Does the tap appear to open fully and are there any shut off valves in the pipeline before the tap? Sorry to be inconclusive but without these details it's not easy to diagnose a likely fault. Cheers, Andy
This is an easy one.
I had the same problem - drove me nuts, esp when taking a bath.
The hot water tank is in turn fed from the water storage tank - the one with the stop-**** in. The pressure of the hot water is directly affected by the speed at which it's replaced by the cold water tank. What happens is over years of use, the stop-**** gets clogged - there's only a minute hole for the water to feed through anyway. So if you replace your stop-**** assembly, (costs about a tenner) you should solve your problem. I did it a few weeks back, and it's made a huge difference. (Stop-**** assembly just screws on and off, inside the water tank)
I had the same problem - drove me nuts, esp when taking a bath.
The hot water tank is in turn fed from the water storage tank - the one with the stop-**** in. The pressure of the hot water is directly affected by the speed at which it's replaced by the cold water tank. What happens is over years of use, the stop-**** gets clogged - there's only a minute hole for the water to feed through anyway. So if you replace your stop-**** assembly, (costs about a tenner) you should solve your problem. I did it a few weeks back, and it's made a huge difference. (Stop-**** assembly just screws on and off, inside the water tank)