ChatterBank4 mins ago
Waeco fridge problem
4 Answers
I have a waeco mdc compressor fridge istalled in a camper van. The fridge only cools when the van is being driven. It stops after about 1 hour after a drive, even when hooked up. any ideas?
Answers
Best Answer
No best answer has yet been selected by pariskyle. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.Check out the online forum at the following :
http://www.refrigeration-engineer.com/forums/
Someone just may be able to help you.
http://www.refrigeration-engineer.com/forums/
Someone just may be able to help you.
Hello again.
The model is a WEBASTO WAECO MDC model.
Check out the Waeco site at the following :
http://www.waeco.co.uk/shop/shop.aspx?c=3&s=13 &i=
If the link doesent work then just go to www.waeco.co.uk
I am not too hot on this type of absorbtion fridge systems, but if you try and contact (Webasto) Waeco direct they may have a technical advice contact.
Always write down the model and serial number & any other numbers,letters or details.
Good Luck
The model is a WEBASTO WAECO MDC model.
Check out the Waeco site at the following :
http://www.waeco.co.uk/shop/shop.aspx?c=3&s=13 &i=
If the link doesent work then just go to www.waeco.co.uk
I am not too hot on this type of absorbtion fridge systems, but if you try and contact (Webasto) Waeco direct they may have a technical advice contact.
Always write down the model and serial number & any other numbers,letters or details.
Good Luck
I searched the site.
Post your question to the following :
[email protected]
Make 100% sure you give them every detail including model and serial numbers.
Post your question to the following :
[email protected]
Make 100% sure you give them every detail including model and serial numbers.
Here�s how absorption refrigeration works: a concentrated ammonia solution is heated in a hermetic system and driven off as vapour. The pressurised ammonia gas is then liquefied in a condenser and supplied with hydrogen. As a result, it evaporates and, in the process, extracts heat from the food storage space. The ammonia gas then enters the absorber where it is reabsorbed in a weak solution of ammonia. Finally, the saturated solution flows back to the boiler where the whole cycle starts again. The boiler can be powered by either gas, 12 or 230 volts.
Related Questions
Sorry, we can't find any related questions. Try using the search bar at the top of the page to search for some keywords, or choose a topic and submit your own question.