Drilling Holes Into Plastic Pots

Tilly2 | 08:33 Fri 17th Jun 2016 | Home & Garden

29 Answers

I have bought two plastic garden pots but there are no drainage holes in them. How do I drill holes in the base of the pots, safely? I don't want to crack the base.

Is there a technique for doing this please?

Freda 1000 Handbook

Soundproofing Of Partywall

Answers

1 to 20 of 29

1 2 Next Last

Best Answer

No best answer has yet been selected by Tilly2. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.

RATTER15

As long as the pots are fairly thick, just use a sharp drill bit, if the pots are thin, use a small drill bit first before going up to the size you want. should be fine. drill a few small holes rather than just a couple of large ones.

gingejbee

Very small drill-bits, very slow speed, bit of sticky tape on plastic to prevent bit from skipping....and support the other side of the plastic - so you're not drilling into empty space.
Or, buy some with holes!

Old_Geezer

Don't push too hard. Consider drilling small holes first then widening them with increasingly bigger diameter drills.

Tilly2

Question Author

They are thick, good quality plastic, Ratter. Thank you. I shall use a small bit first and see how I get on.

retrocop

There should be about 3-5 indent guides at bottom of pot for drilling with any HSS or even a sharp awl will do it. Mrs retro re potted last week and used my drill to do it. Easy peasy. :-)

RATTER15

If they are thick it it should be plain sailing Tilly.

gingejbee

OH has just suggested a meat skewer from the inside.....take your pick!

Tilly2

Question Author

......and thank you, others who have answered.

Ginge, they didn't have any with pre-drilled holes, otherwise I would have bought them. I'm not that daft.

RATTER15

gingejbee, I cant see a meat skewer doing anything to be honest, especially if the plastic is thick.

Tilly2

Question Author

What's an HSS, retro?

Tilly2

Question Author

I don't have a meat skewer.

RATTER15

HSS = High Speed Steel = an ordinary drill bit.