Crosswords1 min ago
Wall Lights
Hello, I have a 1930's fireplace in my terraced house. On the side of the mantle is a small switch to power 2 wall lights on top. These lights have a wooden sqaure base attached to the chimney breast.
The lights have a round plate screwed to the wooden base, they have a small "pipe" the comes out and bends up to give you the bayonet fitting for the actual light. The actual light wire comes through the pipe...
I want to replace these lights but dont know how to remove them. I can unscrew the round base from the wood and see the wires going through the pipe... the bayonet end of the fitting unscrews also (leaving the actual bayonet in place at the end of the pipe.
How does one remove these lights, other than chopping the wires and leaving no slack to play with for the new fittings?
Thanks.
The lights have a round plate screwed to the wooden base, they have a small "pipe" the comes out and bends up to give you the bayonet fitting for the actual light. The actual light wire comes through the pipe...
I want to replace these lights but dont know how to remove them. I can unscrew the round base from the wood and see the wires going through the pipe... the bayonet end of the fitting unscrews also (leaving the actual bayonet in place at the end of the pipe.
How does one remove these lights, other than chopping the wires and leaving no slack to play with for the new fittings?
Thanks.
Answers
Best Answer
No best answer has yet been selected by moore_ag. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.Try sliding the wooden base up the wall as if it was hanging on a screw.
If the wiring supplying the fitting is fairly recent the connection for the lights will be made behind the base and I would not worry about the wires being too short as I would have a guess the new ones will attach to the ends quite easily.
If they do end up too short get a spark to replace the wiring or else solder a new wire to the ends and use some heat shrink sleeving to insulate them.
If the wiring supplying the fitting is fairly recent the connection for the lights will be made behind the base and I would not worry about the wires being too short as I would have a guess the new ones will attach to the ends quite easily.
If they do end up too short get a spark to replace the wiring or else solder a new wire to the ends and use some heat shrink sleeving to insulate them.