remote control mondeo

[grahamlane1]

how do I reprogram my 1996 Mondeo remote after fitting a new battery to fob?

[Dick Cheese]

Hi Grahamlane1,

Not sure which type of keyfob you have, so i have included for both types.  I have not tried this on a Mondeo, but it worked on a 1998 Fiesta. Ford where goining to charge me �50 for this 20 second job!

If none of the ways below work, the instructions can normally be found in a Haynes manual.

Infrared Programming Instructions:

Put your key into the ignition and turn to position 1 (Radio). After approximately 10 seconds the red alarm control LED (next to the clock) should illuminate. As soon as it comes on remove the key from the ignition - the LED should remain lit.
Point the remote's "eye" at one of the front door sensors and press the rear button until the light on the transmitter illuminates (Keep the button pressed)
With the rear button held in press the front button 4 times then release both at the same time. The control lights in both clock and fob will flash 4 times to indicate programming complete.
Turn the ignition back on to exit programming mode

Radio Frequency Programming Instructions:

Insert the ignition key and turn from position II (Ignition) to position 0 (All off) and back four times within three seconds.
Remove the ignition key. The locking control system is now in "learn mode" for the next 20 seconds and the red warning system LED (By the clock) stays on continuously to indicate this.
During the 20 seconds press one of the transmitter buttons. The remotes signal and code number is learned by the locking module and is indicated by flashing the warning system LED.
Wait until learn mode times out (20 seconds) or switch the ignition back to ON.

 

Good luck.

[Ian Wilson]

Many thanks for the info. I used it today when I changed my key fob batteries on my Mondeo 1997.  Ian Wilson

[Harhape]

Hello

I had same problem and that infrared programming worked to my -96 Mondeo

thanks Dick