Quizzes & Puzzles2 mins ago
Home Electrics
9 Answers
My son has just moved house, and there is a switched double socket in the utility room. Each of those sockets has a double socket thingy plugged into it, so there are 4 plugs serving the gas boiler, the freezer, the tumble drier and a small overhead striplight. Is that overloading the original socket?
Answers
Best Answer
No best answer has yet been selected by greenrook. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.>>>they're all low power devices plugged into it
I've yet to come across a low-power tumble dryer!
However I agree that there doesn't seem to be any cause for concern. I've probably got more than a dozen low-power devices (such as radios and phone chargers) connected into some of my 13A sockets but the total load still doesn't come anywhere near to the maximum. It's usually only devices that convert electricity into a substantial amount of heat (such as kettles, fan heaters, etc) that you need to be careful about.
I've yet to come across a low-power tumble dryer!
However I agree that there doesn't seem to be any cause for concern. I've probably got more than a dozen low-power devices (such as radios and phone chargers) connected into some of my 13A sockets but the total load still doesn't come anywhere near to the maximum. It's usually only devices that convert electricity into a substantial amount of heat (such as kettles, fan heaters, etc) that you need to be careful about.
You will most probably overload a circuit breaker before overloading the socket. If so it should blow.
I believe a wall socket (single or double since it uses the same single connection at the back) is expected to pass about 15A but I am prepared for the electrical experts to correct me on that.
At 230v this would be about 3.45 kW. You may add up the wattages given on each of your son's appliances to see if they add up to more than that.
That said it isn't good practice to put break-out boxes in series, but four loads from a double socket shouldn't be a problem.
Recall that the gas boiler will take very little as it is just using electricity for running its electronic control circuitry, not heating the house. The freezer may spike due to induction, but is not permanently taking power: it goes on for a short while then off again. The tumble drier also is only taking power when on. Lighting is minimal.
I believe a wall socket (single or double since it uses the same single connection at the back) is expected to pass about 15A but I am prepared for the electrical experts to correct me on that.
At 230v this would be about 3.45 kW. You may add up the wattages given on each of your son's appliances to see if they add up to more than that.
That said it isn't good practice to put break-out boxes in series, but four loads from a double socket shouldn't be a problem.
Recall that the gas boiler will take very little as it is just using electricity for running its electronic control circuitry, not heating the house. The freezer may spike due to induction, but is not permanently taking power: it goes on for a short while then off again. The tumble drier also is only taking power when on. Lighting is minimal.