Bath fittings

[fever28]

I have a bath where the taps are located in the middle of one of the long sides nearst the wall (normal)

the plug is buitl in nd there is large metal disk under the taps that you turn to open and close the plug.

my problem is this metal disk has come lose (hanging off loose) I dont see a way of tigtening it back up.

(bath can't be removed and there isnt any way for me to get to the back of this fitting.)

[wagw81]

Usually on the side of the metal disk there is a small hole with an adjuster screw that holds the metal disk onto a spindle which pushes the plug up or down. If you can see this try and tighten the screw inside. If not, then you would probably be looking at removing the bath panel or front fixtures to gain access to the rear.

[tezestwing]

Hi fever what sort of long wall have you got because if you can't remove the bath then you may have to go from the other side this includes of course an external wall easier than you think if it is cavity, drill all round bricks to remove then longer drill/chisel inner course then re build after repairs internal studding a bit easier than removing bath disturbing tiles etc HTH Tez