Motoring0 min ago
Tiling Over Tiles?
18 Answers
Is it ok to tile over existing tiles? I've had a quote to have my bathroom re-tiled and the tiler has said it will be quicker and cheaper to tile over the tiles I have. My bathroom is fully tiled. The only loose tiles are just over the bath and three rows up. He says he will remove them and build up the wall there flush with the tiles before he starts putting on the new tiles. Are there any disadvantages to tiling over existing tiles? Would you recommend I get all the tiles off so he can start from scratch? Will getting the tiles off pull much plaster down? Thank you
Answers
Best Answer
No best answer has yet been selected by Marijn. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.The one issue with removing the old tiles is that they may not come away without taking most of the plaster with them. I re-tiled my bathroom and ended up having to dot and dab the entire back wall before I could tile it. The benefit to doing this meant I could use aquaboard instead of the plasterboard the cowboy builder used when he built the house.
One problem you'll have is that if you have any electrical outlets or switches on the walls to be double tiled, the switches and outlets under the face plates will have to be reset and extended to the new double-tiled surface. This can be quite an expense, at least here in the U.S. since, while the job isn't terribly difficult, most "trades" (plumbers, electricians, tilers, etc) won't do work on those items that are not their specialty for fear of violating some code or other. You may wish to check into that...
As they are hee in the U.S. but only as long as they are no nearer than 3 feet to any water source...
Extension bolts don't do any good since they screw into the box in which the actual connection resides, not the connector itself... leaving the actual "plug-in" or switch indented by nearly 1/2 inch or so...
Extension bolts don't do any good since they screw into the box in which the actual connection resides, not the connector itself... leaving the actual "plug-in" or switch indented by nearly 1/2 inch or so...