Donate SIGN UP

gasman

181 to 200 of 719

First Previous 7 8 9 10 11 12 13 Next Last

Avatar Image
maxiewaxie
I am now on my third kitchen tap in 6 months and I find it hard to believe that I have bought 3 faulty taps as they from different suppliers and fitted by different plumbers. The tap I had when I...
Avatar Image
DIY-NOVICE
My ground floor radiators are all cold at the bottom to some degree to worst has about 10 cms of hot at the top. Having read some of the posts I suspect that it may be sludge in the system but how...
Avatar Image
ray bush
I have an ideal wall mounted boiler which is about 3 years old .The problem i've got is that it has developed a fault whereas it goes to ignight but dosnt light and just clicks.Its under one of these...
Avatar Image
ELVIS68
I have an oil fired central heating system in my house and whenever it fires up the boiler has started to make a very loud whining noise, the heating and hot water still work ok but every now and then...
Avatar Image
anna_whd
We will be exchanging on our first house in a couple of weeks and, following bad experiences a couple of friends have had recently, we would like to get the central heating checked beforehand just to...
Avatar Image
sense4all
have been on website to try to locate f5 fault indictor code ... anyone got the user book and fault list handy?
Avatar Image
afc01
Is it possible to embed pipes into a wall, that are currently on the surface of a wall? Therefore providing clean straight walls
Avatar Image
Hannahb
We had a new boiler and thermostatic valves installed 18 months ago. Made it a sealed system and fitted a pressure gauge and, I think, disconnected a small tank in the attic? Central heating (CH) was...
Avatar Image
chadwick21
Hi, Wonder if anyone can help. We have just moved to another house, with a combi boiler worcester 24i/28i Junior series. The pressure Guage is under 1 when it should be between 1.0 - 2.5. The...
Avatar Image
Whickerman
How much does a new replacement copper water tank cost? (the one containing the immersion in the hot press - you know what I mean!)
Avatar Image
D123456A
Hiya, This is my first posting so please help me out :) My parents will be receiving a warm front grant, they are going to take out the water tank and fit a combi boiler. My parents have a Maxi...
Avatar Image
Peppermint
Can anyone tell me why the pilot flame on my bottled gas heater is burning yellow and a slow rather than blue and fast as it should? The gas connections seem to be all ok.
Avatar Image
patelfreman
I visited some relatives at the weekend and looked at the work they had done which included fitting a new boiler. However I was concerned that the plumber had run the gas (in a copper pipe) through an...
Avatar Image
forshaws
I have had a new central heating boiler fitted at my property in June 2006 by a friend who is not corgi registered at present, however has 30 years experience at fitting gas central heating systems. I...
Avatar Image
Bribo
When a new boiler is fitted, if the radiators in the house at the time have no thermostatic rad valves, should the fitter also fit the valves to comply with government rules, which I believe says that...
Avatar Image
malibu2680
Hello, a couple of months back I had my annual boiler service, but as it's summer I didn't think to check the heating still worked after he left...Anyway this might be coincidence, but basically my...
Avatar Image
Deancosmos
Hello all. We are considering having our loft converted to give us 2 more bedrooms and a shower room. We would need a hip to gable extension and a full width dormer at the rear. Two questions, is a...
Avatar Image
jabbinho
The pipe under the hot water tap in my bath is leaking. I've tried tightening the nut but the tap itself moves when I turn the nut. I've tried WD40 on the nut to loosen it from the tap fitting but no...
Avatar Image
wagw81
Does anyone know if there is a product available to repair a victorian cast iron soil pipe ? like a compound or chemical banding ?- It has mild corrosion above ground and is weeping when the toilet is...
Avatar Image
kevo2k7
the walls are 2 hard 2 hammer nails through etc so any ideas what i could use to pin the wire to the corner of the room so it doesnt just hang down lookin an untidy mess?

181 to 200 of 719

First Previous 7 8 9 10 11 12 13 Next Last